LinxVIEW论坛-斯科道

标题: LabVIEW Raspberry Pi　软件安装环境指南 [打印本页]

---

作者: Scadao    时间: 2019-4-16 19:33
标题: LabVIEW Raspberry Pi　软件安装环境指南
LabVIEW Raspberry Pi　软件安装环境指南

---

作者: Scadao    时间: 2019-4-16 20:13

• 原文链接
  
• 
  
• Download a Raspbian image
  
  • LINX was developed using Raspbian Jessie.
    
    
• Unzip the Raspbian image.
  
  
  
• Download and Install Win32 Disk Imager.
  
  
  
• Use Win32 Disk Imager to load the Raspbian image onto an SD card.
  
  
  
• Insert the SD card into the Raspberry Pi.
  
  
  
• Connect ethernet to the Raspberry Pi
  
  
  
• Power on the Raspberry Pi.
  
  
  
• Note: The next step requires that the RPI has SSH enabled, however as of November 2016 Raspbian has SSH disabled by default. Manually enable SSH by following these instructions.
  
  

• Launch LabVIEW and open the Target Configuration Wizard from Tools»MakerHub»LINX»Target Configuration.
  
  
  
• Enter the Raspberry Pi's Hostname or IP and a username and password with root privileges and click connect.
  
  • Default Hostname is 'raspberrypi'.
    
  • Default Username is 'pi'
    
  • Default Password is 'raspberry'
    
    
    
• Click the Install Software tab.
  
  
  
• Click Install.
  
  
  
• Review any warnings and complete the installation.
  
• 
  
  

---

作者: Scadao    时间: 2019-4-16 20:31

原文链接

• Open example finder by clicking Help»Find Examples.
  
  
  
• Search for LINX.
  
  
  
• Open LINX - Blink Advanced.
  
  
  
• Save a copy of the example to the desktop, name it Blink and close the original.
  
  
  
• Create a new empty LabVIEW project by clicking File»New»Empty Project.
  
  
  
• Choose to add the Blink VI to the project when prompted.
  
  
  
• Add a new LINX target to the project:
  
  • Right click the top project item and choosing New»Targets and Devices.
    
  • Expand the LINX folder to discover LINX devices on the network
    or
    
    
  • Choose New Target or Device, exapnd the LINX folder and select the appropriate target type. (Make sure to manually set the IP).
    
    
    
    
• Right click on the LINX target in the LabVIEW Project and choose Connect.
  
  
  
• Open the Blink VI.
  
  
  
• Switch to the Block Diagram.
  
  
  
• Change the LINX Open from Serial to Local I/O and remove and broken wires.
  
  
  
• Save and close the Blink VI.
  
  
  
• Move the Blink VI under the LINX target in the LabVIEW Project.
  
  
  
• Open the Blink VI.
  
  
  
• Update the Digital Output Channel to match the DO channel connected to the LED.
  
  
  
• Run the VI.
  
  
  
  

---

欢迎光临 LinxVIEW论坛-斯科道 (http://linxview.com/)

Powered by Discuz! X3.2